ADDITIONAL SAFETY INFO
For U.S.A
TO THE USER
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accor- dance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residental area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
CAUTION
Changes or modifications to this equipment not express- ly approved by Stanton for compliance could void the user's authority to operate this equipment.
This product has been designed and manufactured according to FDA regulations "title 21, CFR, chapter 1, subchapter J, based on the Radiation Control for Health and Safety Act of 1968", and is classified as a class 1 laser product. There is no hazardous invisible laser radiation during operation because invisible laser radiation emitted inside of this product is completely confined in the protective housings.
The label required in this regulation is shown 1
CAUTION
- DO NOT REMOVE THE PROTECTIVE HOUSING USING A SCREW- DRIVER.
-USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.
-IF THIS PRODUCT DEVELOPS TROUBLE, CONTACT YOUR NEAR- EST QUALIFIED SERVICE PERSONNEL, AND DO NOT USE THE PRODUCT IN ITS DAMAGED STATE.
For the consumers in Europe
WARNING
This is a Class A product. In a domestic environment, this product may cause radio interference in which case the user may be required to take adequate measures.
Pour les utilisateurs en Europe
AVERTISSEMENT
Il s’agit d’un appareil de Classe A. Dans un environ- nement domestique, cet appareil peut provoquer des interférences radio. Dans ce cas, l’utilisateur peut être amené à prendre des mesures appropriées.
Fur Kunden in Europa
Warnung
Dies is eine Einrichtung, welche die
Rack Mounting the Unit
The units should be mounted, using the supplied rack mounting kits. A typical configuration is shown below, but other configurations are possi- ble:
NOTE
Do not install this apparatus in a confined space such as a book case or similar unit.
Optical pickup:
Type:
Manufacturer: SONY Corporation
Laser output: Less than 0.4 mW on the objective lens
Wavelength: 760 - 800 nm