TE C H N I CA L S P E C I FI CA TI O N S
Line inputs: 8(RCA), 150 mV / 27K ohm
Phono inputs: 4(RCA), 3mV / 47K ohm
DJ mic input: 3(XLR, 1/4“), 2.45 mV / 3K ohm
Effect Send: 1 (1/4”), 775mv
Effect Return: 1(1/4”), 245mv
Master output: 1(RCA), 1.2 V / 1K ohm
Booth output: 1(RCA), 1.2 V / 1K ohm
Record output: 1(RCA), 245 mV / 10K ohm
Headphone output: 1(1/4”), 32 -200 ohms recommended
Frequency Response: 20 Hz - 20 kHz, +/- 2dB
Tone Control : +9/-26 dB (Hi, Mid, L ow)
Mic Tone: Hi/Mid/Lo+/-10 dB
Gain Control: 0-20dB
S/N Ratio: Less than 70dB
T.H.D: less than 0.2%
Dimension(LxWxD): 19” x 10.5” x4” (482 x 267 x102 mm)
WA R R A N TY
This unit has been designed and manufactured using quality
components. Therefore, it is warranted to be free from defects in materi-
als (limited as specified below), and workmanship for a period of twelve
(12) months from the original purchase date. During this period, all
service and parts necessary to repair a defect will be free of charge. This
limited warranty applies to mechanical parts which are subject to wear
and tear as specified:
• Faders, specified durability: 15,000 cycles
• Rotary potentiometers, specified durability: 10,000 cycles
• Switches, specified durability: 10,000 cycles
Consequently, the parts listed above are warranted to be free from
defects in materials and workmanship for a period of thirty days (30)
days from the original purchase date.
FOR THE WA R R A N TY TO BE VA LID, PLEASE CO M PLE TE THE
O N LINE WA R R A N TY REGIST R ATION FORM FO UND AT
W W W. STA N TO N M AG N E TI CS . CO M
Stanton Magnetics, LLC,
Hollywood, FL 33020
channel controls (24).
30. Audio signal inputs: Line inputs are used to connect to line level sources such as CD
players, samplers, tape players, etc. Phono inputs are used to connect to turntables.
Mic inputs connect directly to microphones. To prevent potential circuit damage, never
connect line level source to phono inputs.
31. Fader Start connector: Connects to the sound module’s remote start output (such as
Stanton’s S-Series CD players) to control the cue-start via the mixer’s crossfader.
32. Audio signal outputs: Master output connects to an amplifier, EQ, crossover, or other
outboard signal processing. Record out connects to tape recorder, mini disk recorder,
etc. Booth output is a second master output used mostly for in-booth monitoring.
33. AC cord connector: Input connection for the supplied removable AC cord.
34. Send/return connetions: Connect the send output to the input of an outboard signal
processor, such as the Stanton DJF-1 DJ filter. Connect the return input to the output of
the outboard signal processor to create an effect loop.