Stanton VRM-10 owner manual Depth, Select, 20 on / OFF / Flash, Input Channels, Crossfader, Gain

effect individually. The middle position of this control will have the value of the individual selected effect preset indi- cated in the diagram above.

18 DEPTH

With this control you can adjust the intensity of the LFO

19 SELECT

With this switch you can choose the channel on which the effect should work. The following 6 positions are available:

MIC	Microphone channel
CH1	PGM1
CH2	PGM2
CH3	PGM3
CH4	PGM4
MA	Master section

20 ON / OFF / FLASH

With this switch you can turn the effect on or off. In the FLASH position you can temporarily trigger the effect.

INPUT CHANNELS 1-4

Input channels 1-4 are identical. Therefore we will only

describe PGM1:

21 SELECT

With this switch you can select one of the three inputs:

TT	PHONO	(M)
L1	LINE 1	(I)
L2	LINE 2	(H)

22 CROSSFADER

This switch will select to which side of the crossfader the the signal of the selected channel should be routed. The blue LED’s to the left and right of the crossfader will indi- cate the chosen selection:

AThe signal comes through the left side of the cross fader

POST The signal bypasses the crossfader

BThe signal comes through the right side of the crossfader

23GAIN

24LED Clip

With this control you can set the volume of the incoming signal of your selected input (SELECT 21). When setting this control in the right position, the CLIP-LED will only light up occasionally during really loud peaks of audio signals.

25 AUX

With this control you can set the volume and intensity of the auxiliary output.

26 TREBLE

27BASS

28MIDDLE

29MID FREQ

With the EQ you can set the level of each frequency. Furthermore the EQ can be used to isolate certain frequen- cies. This is very easy and effective with the high quality and very strong filter-type parametric EQ on your VRM10.

NOTE : As the VRM-10’s EQ is so powerful, you may have to carefully adjust the GAIN (23) while using the EQ (26-29)

30 CHANNEL FADER

With the fader you can set the volume of the input channel

The VRM10 is equipped with high quality faders. Nevertheless a fader has no life-time warranty (see war- ranty section) as it is used in a heavy duty way. If the fader ever needs replaced, we have made it easy to be replaced:Just loosen the 4 screws around the fader; then disconnect the fader and replace with the new part. Connect the fader back into the socket and screw the 4 screws back into their holes.

31 PFL

In the headphones you will hear the signal of the master output if none of these buttons are activated: PFL (31), EFFECT (57) and FILTER (56). If you press any PFL switch you will here the selected audio signal before the master output signal.

NOTE : It is possible to select more than one channel with the PFL option.

CROSSFADER

32 Crossfader

With the crossfader you can control and mix the various audio channels. You must have selected which channel runs through the crossfader, though. This selection can be made with the CROSSFADE switch (22).

Using modern VCA-technology in the VRM10 prevents early damage of the crossfader. Nevertheless, once in a while every fader gets worn out and needs to be replaced. To change the crossfader easily you only need to unscrew the two screws on the fader and disconnect the socket. Then you need to connect the new fader and put the screws back into their place.

33/34 TRIGGER

With both these buttons you can punch-in the audio signal on whichever side of the crossfader you would like to hear it, no matter in which position the crossfader is. By press- ing both buttons you will hear both audio signals on either side of the crossfader.

4