Stanton VRM-10 owner manual Filter, Effect, Technical Characteristics, Warranty

Ohm. You will hear the master signal in your headphones if you haven’t selected any of these options: PFL (31), EFFECT (57) and FILTER (56).

56 FILTER

When the FILTER switch (56) is selected, you will hear the mixed master signal before the activated DJ filter or master effect. When the FILTER switch is in its up position

(off), the master signal is set to post-filter.

57 EFFECT

By pressing the EFFECT switch you can pre-listen to the internal effect signal.

NOTE : The PFL and EFFECT monitor switches must be off monitor the filter from the headphone output.

TECHNICAL CHARACTERISTICS

Mic Inputs	(Mic1 + Mic2)	Internal Effects
Sensitivity	-46dBu	Frequency Range	20Hz-15kHz
Impedance	10kOhm	THD+Noise	0,025%
S/N Ratio	>80dB	S/N Ratio	86db
THD+Noise	<0,1%	Effects	8 x Reverberation
EQ High	+/-15dB, 10kHz		4 x Delay
EQ Mic	+/-15dB, 1,1kHz		4 x Flanging
EQ Low	+/-15dB, 50Hz
		Filter
Input 1-4		Mode	Band/Notch
Sensitivity	-20dBu (Line1+2)	Frequency Range	50Hz-15kHz, 24dB/Octave
	-60dBu (Phono/RIAA-Filter)	Resonance	+6dB
Impedance	100kOhm (Line1+2)
	50kOhm (Phono)	Headphones
S/N Ratio	>85dB	Impedance	30-200Ohms
THD+Noise	<0,1%	Frequency Range	20Hz-20kHz
EQ High	+/-15dB
EQ Low	+/-15dB	Mains
Parametric EQ	+/-25dB (100Hz-10kHz)	Power Consumption	50VA
AUX-Level	0dBu	Voltage Selector/Fuse	230V/500mA
			115V/1A
Master			100V/1A
Effect-Loop	0dBu	Dimensions
Booth	0dBu	Front	483mmx355mm (19"x8)
Master1	0/+6dBu switchable	Chassis	436mmx352mmx100mm
Master2	+6dBu	Weight	approximately 10kg
		WARRANTY

This unit has been designed and manufactured using qual- ity components. Therefore, it is warranted to be free from defects in materials (limited as specified below), and work- manship for a period of twelve (12) months from the origi- nal purchase date. During this period, all service and parts necessary to repair a defect will be free of charge. This lim- ited warranty applies to mechanical parts which are subject to wear and tear as specified:

•Faders, specified durability: 15,000 cycles

•Rotary potentiometers, specified durability: 10,000 cycles

•Switches, specified durability: 10,000 cycles

Consequently, the parts listed above are warranted to be free from defects in materials and workmanship for a peri- od of thirty days (30) days from the original purchase date.

FOR THE WARRANTY TO BE VALID, PLEASE COMPLETE THE

ONLINE WARRANTY REGISTRATION FORM FOUND AT

WWW.STANTONMAGNETICS.COM

Stanton Magnetics, LLC, 2821 Evans Street • Hollywood, FL 33020 (954) 929-8999 Fax: (954) 929-0333

© 2000, Stanton Magnetics, LLC

6