Star Micronics SCP700 Series

1B 19 nm0A 00

Set the wait time until the automatic clamp is activated

Set the wait time between paper insertion (TOF/BOF sensor senses

the paper) and automatic clamp activation by n × 0.1 sec.

The default value of n is 7 (wait time is 0.7 sec.)

The value of m is fixed to 0.

This command is only valid with the slip printer, besides memory

switch 5-1 is set to 0.

Page Mode

<ESC> “n”

1B 6E

Select page mode

Switches from line mode (default) to page mode.

This code is only valid when it is entered at the beginning of the line.

The page mode is suitable even though data is printed in the

rotational direction specified by <ESC> “T” n and in the page

coordinate range specified by <ESC> “*” •••, and though paper with

a horizontal length of a check, etc. is rotated 90 or 270 and printing

is carried out in all modes.

In page mode, since OR is applied to the data in the print area,

characters and bit images can be printed overlapping each other and

each character can be rotated and oriented independently.

In page mode, if printing data and a command such as <CR> or

<LF> are sent in the same way as in line mode, there is an automatic

rotation to the printer side.

All printing of data in the print area is performed according to <LF>.

After printing according to <FF>, the printer returns to line mode. In

addition, if <ESC> “!”, <ESC> “@” or <CAN> are specified,

printing is not performed and the printer leaves page mode and

returns to line mode.

While returning to line mode, the data in the printer buffer, the area

coordinates and the rotation directions are all cleared.

This command is only valid with the slip printer.

The following restrictions exist in page mode.

1) In page mode, half-dot characters cannot be printed since

printing is carried out in normal dot units.

When entering page mode, the ANK font is automatically set to

a 5 × 9 (2 pulses = 1 dot) font.

Since the 7 × 9 font and 5 × 9 (3 pulses = 1 dot) font commands

cannot be executed in page mode, they are executed after the

CODE

HEX

FUNCTION

CODE

HEX

FUNCTION