Instruction Manual
Contents
•1 x
•1 x User Manual
•1 x USB Type A to B cable (for Standalone use)
•1 x USB Type B to motherboard header cable
•Four Screws
•Four Rubber Pads
Installation
Panel Installation
Note: The instructions below outline how to install the card reader into a 3.5” drive bay. Alternatively, you can use your card reader externally by plugging the USB cable into an open USB port.
1. | Make sure that your system is unplugged and you are grounded. | |||||
2. | Remove the cover of your system and remove the cover from a 3.5” drive bay (see | |||||
| your computer’s user manual for details, if necessary). | |||||
3. | Gently insert the panel into the open 3.5” bay (after threading the attached USB | |||||
| cable into the computer) until it is flush with the front of the case. Make sure the | |||||
| bracket is lined up with the screwholes in the case, and screw the panel into place. | |||||
4. | Connect the reader to the mainboard, using the 1 x 4 pin header to USB Type ‘B’ | |||||
| cable. Based on the following table, please ensure that the pin assignments are | |||||
| correct: |
|
|
|
| |
|
|
|
|
|
|
|
|
| Pin 1 (Red) | Pin 2 (White) | Pin 3 (Green) | Pin 4 (Black) |
|
|
|
|
|
|
|
|
|
| USB 5V | DATA- | DATA+ | GND |
|
5. | Replace the cover on the computer. |
|
| |||
6. | Your computer will display a message saying new hardware has been found. | |||||
| Windows 98SE and 2000 users follow the | |||||
| to the appropriate folder on the driver disk. Windows will install the necessary drivers. | |||||
2
