Initializing the printer 27
Important!
Be sure to stop the print job before taking the printer off line. Otherwise, the
print job will resume from where you interrupted it when you put the printer
back on-line.
❏Use ON LINE to take the printer off line (ON LINE indicator is not lit).
❏Hold down FONT and then FORM FEED. Keep both buttons held down
until the printer beeps once, which indicates that the buffer is cleared.
Initializing the printer
The following procedure initializes the printer to its power-on settings. If you
have control panel settings stored in memory, this procedure sets up the printer
using them.
❏Use ON LINE to take the printer off line (ON LINE indicator is not lit).
❏Hold down FONT and then FORM FEED. Keep both buttons held down
until the printer beeps once (indicating the printer buffer is cleared) and
then beeps again three times, which indicates that the printer is reset.
Entering the Multi-part Mode
When the printer is in the Multi-part Mode, the print head prints with greater
impact. It should be noted, however, that printing in the Multi-part Mode also
reduces the life of the print head. Because of this, you should use the Multi-part
Mode only for printing on four or five-ply paper. Return to the normal mode for
printing on one to three-ply paper.
Use the following procedure to enter the Multi-part Mode
❏Turn off the printer.
❏While holding down the control panel’s SET/EJECT/PARK button, turn
the printer back on.
❏To exit the Multi-part Mode, Simply turn the printer off and back on again.