Star Trac NXT 7000 manual 3 of 9Star Trac Product Support

Page 3 of 9Star Trac Product Support 800-503-1221

NXT Only

1. Position the leg so the thicker end faces toward the front of the bike

2. Using the 5mm hex wrench and a 13mm combination wrench insert 2- M10X55mm (rear- most holes) and 2-M10X65mm (front-most holes) button head screws, nuts and washers (under bolt head and nut), to secure the rear leg assembly to the frame. The nut should be on the bottom of the bike and the head of the screw on the top of the bike.

3. Tighten all hardware securely using a torque wrench to 85 Inch Pounds

Pro & Elite Only

1) Using the 5mm hex wrench and a 13mm combination wrench insert 2- M10X55mm flat head screws, nuts and washers to secure the rear leg assembly to the frame. The nut should be on the bottom of the bike and the head of the screw on the top of the bike.

2) Tighten all screws/nuts securely using a torque wrench to 85 Inch Pounds

Position the bike on a flat surface and adjust the leveling feet so the bike is stable.

Page 3 of 9