Pro & Elite Only

Using the 5mm hex wrench and a 13mm combination wrench insert 2- M10X55mm flat head screws, nuts and washers to secure the front leg assembly to the frame.

Tighten all screws/nuts securely using a torque wrench to 85 Inch Pounds

Step 2 (Pro/Elite)

Move the bike to a flat surface and adjust the four leveling feet so the bike is stable.

3. Install the Saddle and Seat Slider

Install the seat post into the frame and lower it to the lowest position and tighten the pop pin securely. Slide the seat slide into the top of the seat post with the saddle pointed towards the front of the bike.

NXT Only

Rotate the seat slider lock knob as needed so that the slider clamp is in alignment with the guide rail.

There is a locking pin under the saddle that has to be pulled

 

 

up as you move the slider into position. Release the pin

Step 3a (Pro/Elite)

Step 3a (NXT)

when the indicator is within the 0 to 9 range.

Test the seat slide for proper operation and full travel.

Pro & Elite Only

Unscrew the seat slider pin far enough to allow the slider to pass over the pin.

Tighten screw with the slider in the 0 to 10 range.

Test the seat slide for proper operation and full travel.

Step 3b (Pro/Elite)

Step 3b (NXT)

4. Install the Pedals

NOTE: The pedal shafts are marked “R” and “L”. Trying to install the pedals on the wrong side may damage the pedal and the crank arm take caution to attach the pedals to the correct side of the bike.

Install the pedals on the pedal cranks using a 15mm open-end wrench and tighten securely.

Turn the left pedal spindle counterclockwise when threading into the left crank arm; turn the right pedal spindle clockwise when threading into the right crank arm.

Step 4

Page 10

STAR TRAC GROUP CYCLES OWNER’S GUIDE

Page 10
Image 10
Star Trac V-bike Spinner Spinner Pro Spinner Elite Spinner NXT manual Install the Saddle and Seat Slider, Pro/Elite NXT