State Industries GPO75 455 warranty Titan, Commercial Oil Water Heater, C O M M E R C I A L

C O M M E R C I A L

TITAN™

Commercial Oil Water Heater

Meets or Exceeds the Thermal Efficiency and/or Standby Loss

Requirements of the U.S. Department of Energy and Current

Edition of ASHRAE/IESNA 90.1

Titan™ Models Inhibit Lime and Sediment Buildup –

Titan™models are warranted against tank failure due to sediment buildup for three years.

Glass-Lined Tank – Assures years of rust-free clean hot water. 160 psi working pressure.

180° Adjustable Thermostat – Has upper and lower sensing bulbs to average water temperatures at top and bottom of heater for maximum temperature control (120°-180°).

Safety Shutoff – Limits temperature buildup.

UL Listed Oil Burner – Precision engineered to match the units they are used with; designed to fire 1.75 to 5.0 gallons of oil per hour. All models equipped with single phase continuous duty motor 120 volt AC 60 Hz, 3450 rpm with overload switch and interrupted ignition. Standard burners equipped with single stage pump with 1 or 2 line capability. Flame retention principle assures high rate of combustion efficiency, yet maintains low operating noise levels. Fuel unit includes pump, strainer, pressure regulating valve and ignition transformer. Transformer rated at 120 volt AC, 60 Hz with high voltage secondary, UL listed for use with No. 1 and 2 commercial grade fuel oil. Burner mounted cadmium cell relay for flame detection - 15 second safety switch timing eliminates the need for RA890F Electronic Safeguard. Complies with UL 296-MP 1192.

Efficient Combustion Chamber – Precast, high temperature combustion chamber made of alumina silica ceramic fiber. Engineered for maximum insulation and heat reflection. Unique design assures more complete combustion by stabilizing flame pattern.

Interrupted Ignition – Reduces electrical consumption.

Oil Solenoid Safety Valve – Standard on GPO75 385, GPO75 455 and GPO69 700.

3/4” Drain Valve – Provided in lower tank for fast draining.

Two Hand-Hole Cleanouts – Allows easy cleaning on standard models GPO75 385 and larger and ASME models.

Anodic Protection – For longer tank life.

Flame Observation Port – Permits convenient flame check.

Foam Insulation – Saves fuel, helps assure constant temperature, vermin proof.

Jacket – Heavy gauge steel with baked enamel finish over bonderized undercoat. Not approved for installation on combustible flooring.

Easy To Install Burner – Three bolt mounting of burner assures easy installation.

Barometric Draft Regulator

CSA Certified and ASME Rated T&P Relief Valve

CAUTION: Units must be installed on non-combustible surface.

Limited Warranty:

Limited Warranty Outline

–If the tank should leak any time during the first three years, under the terms of the warranty, State Water Heaters will furnish a replacement heater; installation,

labor, handling and local delivery extra.

–NOTE: This Outline Is NOT A Warranty. For complete information, consult the written warranty or State Water Heaters.

Other Features:

–Two layers of high temperature ceramic fiber insulation in combustion chamber

–Flame inspection port opening

–Mounted on rugged channel iron skids

–Multiple anodes for protection

Optional Features:

–Two Stage Pump – For use with underground oil storage tanks.

–ASME Construction – Available on models GPO84 315, GPO75 385, GPO75 455, GPO69 700. ASME units have 160 psi working pressure.

For more information on Titan™ contact: State Water Heaters

500 Tennessee Waltz Parkway, Ashland City, TN 37015

800-365-0024 Toll-free USA www.statewaterheaters.com

SCOSS00105 July 2008R