NEW!
SDV100-400
Non-Condensing
Up To 85%
Thermal
Efficiency
Commercial Gas Water Heater
Exhaust pipe
Air intake pipe draws all combustion
The Sandblaster® Force™ delivers the
For example, in restaurant kitchens, commercial range hoods and exhaust fans draw large amounts of air out of the room. This creates negative air pressure in the room, which can deprive an ordinary commercial gas water heater of sufficient
In negative air pressure situations, downdrafts can occur inside an ordinary water heater, compressing the burner flame, resulting in impaired water heating performance and recovery efficiency. Negative air pressure can also generate Carbon Monoxide buildup, and other potential safety hazards.
Sandblaster® Force™ is the solution, because it doesn’t share the inside air! It is equipped with a
Long Vent Runs Mean Installation Flexibility
The Force™ installs just about anywhere, thanks to intake and exhaust vent runs of up to 135 feet horizontally or vertically on models
■
■ASME Construction available on SDV100 260 and
■
■Labor Replacement Allowance (LRA) for installing contractor if heater needs replacement during basic
■
■Installs with 3˝, 4˝ or 6˝ ** Schedule 40 PVC pipe, depending on the model and vent run.
■Two 45° 3˝ or 4˝ (depending on model) Schedule 40 Elbows, with screen, supplied for use as vent caps. Schedule 80 Elbows on
■Integral Automatic Blower – With 110/120 Volt electrical system. Maximum electrical draw: 2 Amps on SDV75 70, 12 AMPS on all other models.
*Check owners manual and local codes for specific venting requirements. Each 90° elbow reduces maximum run by 5 feet.
**Exhaust vent run on
■Intermittent electronic ignition.
■Reinforced tank design for longer life – The Sandblaster® Force™ glasslined tank is reinforced with extra steel in all the most critical areas, to insure long tank life.
■Removable
■Foam insulation – Reduces heat loss over 21⁄2 times more effectively than standard fiberglass.
■
■
■Multiple Magnesium Anode Rods – for extra protection against electrolytic tank corrosion. SDV75 70 has a single large diameter magnesium anode.
■Tank Inspection Port for easy access to tank interior on all models except SDV75 70.
■Maximum Hydrostatic Working Pressure: 150 psi. (ASME 160 psi.)
|
| The |
|
| Expert’s |
|
| |
WATER HEATERS 500 Lindahl Parkway, Ashland City,TN 37015 | Choice™ |