Sterling 882.00291.00 Setting the Process Air Temperature, E5CN Operating Parameters, Indicator

Setting the Process Air Temperature

When setting the process air temperature, consult with the resin manufacture for the recommended drying temperature.

To change the process air temperature set point with the dryer running:

•Press to raise the set point to the temperature you want.

•Press to lower the set point to the temperature you want.

Restoring the Process Air Temperature Controller (E5CN) to Factory Settings

If the preset parameters on the controller have been tampered with and it no longer properly controls temperature, you can restore the controllers to the factory setup. Call the Service

Department for detailed instructions.

E5CN Operating Parameters

The E5CN controller has several mode selections. Within each mode are numerous parameters that can be set.

The factory has set the security level to protect the critical parameters from being accidentally changed. Below is an explanation of the operating modes you will have access to and on the following page are the manufacturers’ default settings.

Available E5CN Modes

Operation Level

	Indicator	Name	Description
		Run/Stop Mode	When “RUN” is selected, the control is running.
		(r-S)	When “STOP” is selected, the control is stopped.
			When the control is stopped, the STOP display
			lights. The default is set to “RUN.”
		Alarm Value 1	This setting is used to indicate how many degrees
		Mode (AL-1)	the process temperature will be allowed to exceed
		(35°F)	the set point temperature. An alarm output will de-
			energize the heaters and blower.
	Adjustment Level
	Indicator	Name	Description
		Auto-Tune Mode	See Page 19 of Chapter 3 for instructions on how
		(At)	to Auto-Tune your dryer.
			Note: Although the controller is calibrated at
			the factory, the manufacturer
			recommends that the unit be Auto-
			Tuned prior to dryer startup.
		Temperature Input	This setting is used to offset an error between the
		Shift Mode (TnS)	set point and the actual temperature. The entire
			input range is shifted by a set figure
15, 30, & 60 cfm Compact Dryers			23