Sterling Plumbing 76111120 Technical Information, Required Electrical Service, Installation Notes

ENSEMBLETM

Technical Information

Fixture*:		basin area			top area
Bathing well		40″ (101.6 cm) x			52″ (132.1 cm) x
		27″ (68.6 cm)			35″ (88.9 cm)
To overflow		water depth			capacity
		11″ (27.9 cm)			55 gal (208.2 L)
* Approximate measurements for comparison only.
Pump:			Hp	V		Hz	A
1-speed			1.25	120		60	7
Model	Door maximum				Door maximum
	width				height
76111110	58″ (147.3 cm)*				NA*
76111120
* Varies with alternative walls.

Required Electrical Service

Dedicated circuit required, protected with Class A Ground-Fault Circuit-Interrupter (GFCI):

Pump 120 V, 15 A, 60 Hz

Installation Notes

Install this product according to the installation guide.

Pump is supplied with a grounding type plug-in cord. Locate the outlet behind the whirlpool, and within 24″ (61 cm) of the pump.

Do not disassemble the pump or piping as this could void the warranty.

Size the drain cutout to fit the drain assembly that will be used.

Stud positioning is critical.

Studs should be positioned roughly as shown for support clip or roofing nail installation.

16" (40.6 cm)

4"

14"

30" (76.2 cm) (35.6 cm) 6" (15.2 cm) (Typical)

24-1/2"	(10.2 cm)
(62.2 cm)
	8"
	(20.3 cm)

43-1/2"

(110.5 cm)

1-1/2"		42"
	(3.8 cm)
3-1/8" (7.9 cm)		(106.7 cm)

Overflow

Detail

8-3/4"

(22.2 cm) 17-1/4"

(43.8 cm)

Drain Cutout

2" (5.1 cm) D. Drain

8-3/4"	3-1/2" (8.9 cm)
(22.2 cm)

60" (152.4 cm) Min

60-1/8" (152.7 cm) Max

43-1/2"

(110.5 cm)

Pump Motor Location

Recommended Support Clip or Roofing Nail Location (5 total)

	76111100
3" (7.6 cm)	20"
19"	(50.8 cm)
(48.3 cm)

16" (40.6 cm)

60" (152.4 cm)

Product Diagram

ENSEMBLETM 42″ (106.7 cm) BATH WHIRLPOOL Page 2 of 2

1021378-4-E