Stiga 55 COMBI, 48 COMBI manual Installation, Using the Mower

GB ENGLISH

INSTALLATION

LOOSE PARTS IN THE BOX

2 brackets for the grass collector

4 screws for the brackets

1 ignition key (*)

1 battery charger (*)

1 Allen key

1 socket wrench

+ Instruction books

HANDLE (Type I-III)

1.Fold up the lower part of the handle.

2.Install the upper part of the handle mounts using screws, washers and locking wheels. A lug is installed on the right hand side for the starter handle (fig. 1).

3.Then tighten the locking wheels onto the lower part of the handle. When these have been tight- ened, the height of the handle can be adjusted by tightening the screws B with the wrench provid- ed. (fig. 2)

VARIATOR CONTROL (*)

When the mower is delivered, the variator cable is set so that the transmission cannot be damaged. The cable may need tightening, see under heading “ADJUSTING VARIATOR CABLE“ in the sec- tion “MAINTENANCE“.

GRASS COLLECTOR

Raise the collector flap and attach the two brackets to the grass collector with the screws provided. The brackets are marked with L and R and should be installed at the corresponding mark on the rear of the mower (fig. 7).

Fabric grass collector (*): Fit the fabric bag over the steel frame and then snap the bag onto the plas- tic lid (fig. 6).

Plastic grass collector (*): Snap together both halves and then the upper part (fig. 8).

Open the flap on the machine and attach the grass collector to the brackets.

NOTE! The lawnmower can be operated without the grass collector. The grass is then left in a line behind the machine.

HANDLE (Type IV)

1.Unscrew the locking wheels from the chassis and secure the lower part of the handle onto screws B (fig. 3).

2.Secure the upper part of the handle with wash- ers and locking wheels. There is a lug on the right hand side for the starter handle (fig. 1).

3.Then tighten the locking wheels onto the lower part of the handle. When these have been tight- ened, the height of the handle can be adjusted by tightening the screws B with the wrench pro- vided. (fig. 3)

ENGINE BRAKE CABLE

Secure the engine brake cable to the engine brake (fig. 4). Note that the cable should be installed in the direction of the handle.

CABLE HOLDER

Secure the cables in the cable holders (fig. 5):

D: Start/Stop cable + Clutch cable (*)

E: Throttle cable (*) + Clutch cable (*)

F: Electric cable (*) + Variator cable (*)

BATTERY (*)

The electrolyte in the battery is toxic and corrosive. It can cause serious cor- rosion damage etc. Avoid all contact with skin, eyes and clothing.

Before starting for the first time the battery should be charged for 24 hours, see further information under the heading MAINTENANCE, BATTERY.

Insert ignition key (*) into the ignition lock.

USING THE MOWER

COMBI(*)

Your new lawnmower combines two different functions in the same machine:

1. “MULTICLIP“

The machine comes equipped with a plug (P), in- stalled in the ejector opening (fig. 31). The ma- chine can be used for ‘Multiclip’ i.e. the blade finely cuts up the grass during mowing. The grass then falls into the lawn where it is allowed to rot. This provides the lawn with nourishment.

7