GB | ENGLISH |
|
|
SYMBOLS
The following symbols appear on the machine. They are there to remind you of the care and attention required in use.
This is what the symbols mean:
Warning! Read the Instruction Book and Safety Manual before using the machine.
ASSEMBLY
LOOSE PARTS IN THE BOX
1 ignition key (*)
1 battery charger (*)
1 socket wrench
2 nut caps
+ Instruction books
Warning! Keep onlookers away. Beware of objects being flung out.
Warning! Keep hands and feet clear of the cutting deck when the machine is running.
Warning! Before starting any repair work, remove the spark plug cable from the spark plug.
IMPORTANT
Equipment which is marked with an asterisk (*) comes as standard in certain models or countries.
Certain models do not have throttle control. The engine’s speed is set for optimal function and minimal exhaust emissions.
INTRODUCTION
3
5
2
41
1.Throttle control (*)
2.Clutch loop
3.Start/Stop loop
4.Electric start (*)
5.Variator control
FLAP
Install the flap according to fig.
1.Insert the shaft into the hole on the
2.Fold down the flap so that the
3.Insert the
HANDLE
1.Remove rear screw, nut and washer and fold up the lower part of the handle (fig. 3).
2.Screw the lower part of the handle without tightening (both sides). Ensure that the lug for the starter cord is correctly positioned (fig. 4).
3.Install the upper part of the handle using screws, washers and locking wheels (fig. 5).
4.Adjust the handle so that the handlebar is horizontal.
5.Set the required height for the handle and tighten the screws A and B properly (fig. 4).
6.Thread the nut caps onto the front screw heads B (fig. 6).
7.Fold down the spring struts so that the flap is secured (fig. 7).
8.Carefully pull the starter handle and thread the starter cord through the lower and upper lugs. Tighten the upper lug (fig. 8).
ENGINE BRAKE CABLE
Secure the engine brake cable to the engine brake (fig. 9). Note that the cable should be installed in the direction of the handle.
CABLE HOLDERS
Secure the cables in the cable holders (fig. 10):
6
