Stiga 82R2-H manual Assembly, Depth skid, Handle’s support, Cover

GBENGLISH

•Wear tightly fitting clothes and heavy-duty shoes which completely cover the feet.

•The tank should only be half full when operat- ing on slopes. Petrol can leak out.

•The engine must be stopped in the following circumstances:

•When the machine is left unattended

•Before the machine is filled up with petrol

•Always make sure you have a good footing, es- pecially on slopes.

•Check that no one is in front of you or beside you when starting the blades. Keep a steady grip on the steering. The machine will lift when the rotors are started. Use extra caution when backing.

•Always keep at a safe distance to the rotors when working.

•Holding the steering correctly ensures a safe distance.

•No person must come closer than 20 m to the machine when working on slopes. The user must hold the steering firmly with both hands all the time.

•Working on stony or hard ground demands ex- tra attention from the operator. The machine be- comes more unstable.

•Never touch the engine when operating the ma- chine, or just afterwards. Risk for burn injuries.

2.4 AFTER OPERATING

•Allow the engine to cool before putting the ma- chine in a storeroom. Fire risk!

•Remove dirt and foreign material before putting the machine in a storeroom. The area round the petrol tank and muffler must be kept clean from leaves, oil, petrol or other foreign materials.

Fire risk!

•If the petrol tank is to be emptied, do this out- doors and when the engine is cold. Fire risk!

•The machine should be stored in a dry place. The machine must not stored with fuel in the tank in rooms where there are naked flames, sparks or other strong sources of heat.

2.5 MAINTENANCE

•Carry out maintenance regularly. All nuts and bolts should always be tight.

•Only use genuine spare parts which are in good condition. Spare parts must not be repaired. They must be replaced if they are defective. Poor quality spare parts can lead to personal in-

jury. If the muffler is damaged it must be re- placed.

•The engine must be stopped and the spark plug lead disconnected in the following circumstanc- es:

When adjusting the rotors.

When the machine is to be cleaned or repaired. When checking after a collision with a solid hard object. Carry out the necessary repairs be- fore continuing to work.

If the machine begins to vibrate abnormally. Carry out the necessary repairs before continu- ing to work.

•Wear protective gloves when working with the rotors.

3ASSEMBLY

3.1Depth skid

1.Install the depth skid mounting arm (4:B) in the machine and lock using the pin (4:A) and lock- ing pin (4:D).

2.Install the depth skid (4:V) in the mounting arm (4:B) and lock at the desired height using lock- ing screw (4:C). Also see “4.18”.

3.2 Handle’s support

Install the handle’s support (5:E) on the machine. Use the 4 screws, nuts and washers as illustrated in fig. 5.

3.3 Handle

1.Slide up the reinforcement plate (6:F) from un- derneath in the handle’s stay so that the holes correspond.

2.Install the handle with the through screw (7:H) with two washers and nuts as well as the knob (7:1) with 4 washers and screw (7:J). The wave shaped washers (7:K) must be turned with the wave shape facing inwards. Check that the screws also go through the reinforcement plate (6:F).

3.Install the handle’s cross member (8:L) with the supplied screws and nuts.

4.Install the cover (1:I) with 4 screws from under- neath.

3.4 Cover

Install the cover (1:I) with the supplied screws from underneath.

42