working area of any foreign objects (e.g. stones) and be aware of foreign objects during operation of the machine! If the machine becomes jammed e.g. by thick branches, switch off and disconnect the machine from the mains socket before investigating and rectifying the cause of the jam. Take special care when switching the machine on again.
5.Check the flex and all connections for any visible faults before using the machine (plug disconnected). Do not use a faulty flex.
6.Keep the flex away from the cutting area.
7.Do not use the trimmer in wet weather and do not use it to cut wet hedges.
8.Carry the trimmer by the handles provided and keep hands away from the cutting blades.
9.In line with agricultural Trade Association Regulations only persons over the age of 17 may work on their own with electric hedge trimmers. Use is permitted for persons over 16 years if the work is carried out under the supervision of adults.
10.We would recommend that safety clothing is worn during the work and that eyes, ears, hair, hands and feet are fully protected. Protective gloves should also be worn.
11.After switching off the hedge trimmer and before carrying out any cleaning, ensure that the motor cannot be switched on inadvertently by engaging the switch lock. In any case, disconnect plug from mains socket.
12.Check the cutting unit regularly for damage and if damage is discovered, the cutting unit should be properly repaired.
13.Be aware of your responsibility as user towards third parties in the working area.
14.The trimmer must be properly checked and serviced. If the blades get damaged they should only be exchanged in pairs. In the event of damage from impact, specialist’s inspection is essential.
15.Only use extension leads which have been authorised for outside use. These flexes must not be lighter than PVC covered flex conforming to 227 IEC 53. They must be water spray protected. Damaged cables of this unit are only to be replaced by a service station designated by the manufacturer as special tools are
necessary. Equipment which will be used in different outside locations should be connected via
16.Ensure that the equipment is stored safely after use in such a way that the blade cannot be touched.
17.When using the equipment, hold it securely with both hands, stand firmly and ensure that you have sufficient working space. There should be no people, animals or objects within the working area. Select the cutting height so that the blade does not make contact with the ground and you can operate the equipment from a secure position.
18.Take care when transporting the equipment (only with blade cover!).
19.For initial use of the hedge trimmer we would recommend that in addition to reading the operating instructions, you also seek a practical demonstration from an expert.
20.Always ensure that all protective devices and handles are properly fitted. Never attempt to use an incomplete machine.
21.The use of the hedgetrimmer is to be avoided if other persons, above all children, are within the working area.
22.Familiarize yourself with the working area and pay attention to possible dangers which you might not be able to hear due to the noise of the machine.
5.Before Use
Safety Guard (Fig. 1)
Fit the enclosed safety guard in the slot on the hedgetrimmer. The safety shield prevents touching the blades during operation. Hold tool with both hands!
Power connection
The machine can only be connected to a single- phase a.c. current connection. The machine is protectively insulated in accordance with classi- fication II of VDE 0740 and can therefore be connected to sockets without earth connections. Before using the machine ensure that the mains current agrees with the operating voltage data on the machine’s identification plate.
Power Circuit Breaker
Machines which will be used in different outside locations must be connected to a Power Circuit Breaker.
