When the engine has turned over for the first time
STOP
0
3
KN207BA006
NMove master control lever (3) to warm start n and continue cranking
Once the engine is running
STOP
0
3 |
| 2 |
| 4 | KN |
| 207BA007 | |
|
|
NPress the throttle trigger lockout (2) and blip the throttle trigger (4); the master control lever (3) jumps to run Fand the engine begins to idle
143BA012 KN
NPull the hand guard toward the handlebar
The chain brake is released – the chain saw is ready for use.
Open the throttle only when the chain brake is off. Increased
engine speeds with the chain brake on (saw chain is stationary) will quickly damage the clutch and chain brake.
At very low temperatures
NLet the engine warm up briefly with the throttle slightly open
Switching off the engine
NMove the master control lever to the stop position 0
English
If the engine does not start
The master control lever was not returned from the position cold start l to warm start nin time, the engine may be flooded.
NMove the master control lever to the stop position 0
NRemove the spark plug – see "Spark plug"
NDry spark plug
NCrank the engine several times with the starter – to clear the combustion chamber
NReplace the spark plug – see "Spark plug"
NSet the master control lever to warm start n– even if the engine is cold
NRestart the engine
MS 170, MS 170 C, MS 180, MS 180 C | 35 |