STIHL MS 201 C manual 26

English

Mounting the Bar and Chain

Releasing the chain brake

0011BA001 KN

NPull hand guard towards the front handle until it engages audibly – chain brake is released

Fitting the guide bar

1

2	KN
	161BA027

NTurn screw (1) to the left until the tensioner slide (2) butts against the left end of the housing slot

1

161BA029 KN

NFit saw chain around the sprocket wheel (1) and over the guide bar – the cutting edges of the teeth must point to the right

Removing the chain sprocket cover

2
1	KN
	0011BA002

NTurn the captive nut (1) to the left until it hangs loosely in the chain sprocket cover

NRemove the chain sprocket cover (2) with captive nut

3

4	KN
	161BA028

NFit the guide bar over the screw (3) and engage the peg of the tensioner slide in the locating hole (4)

Fitting the saw chain

Put on protective gloves – risk of injury by the sharp cutters!

2	KN
	161BA030

NTurn screw (2) to the right until there is very little chain sag on the underside of the bar – and the drive link tangs engage in the bar groove

24 MS 201, MS 201 C