English
001BA233 KN
NWhile pushing down on the cap, turn it clockwise about 1/4 turn until it comes to a stop.
001BA231 KN
The marks on the tank cap and fuel tank must line up.
001BA241 KN
Tank cap should be properly tightened.
If the tank cap cannot be locked in the fuel tank opening
Check cap for tightness. If it can be moved, the bottom of cap may be twisted out of the correct position for installation in relation to top.
NRemove the cap from the fuel tank and check it from above.
001BA239 KN
NPlace the cap in the fuel tank opening and rotate it counterclockwise until it drops fully into the opening.
NContinue rotating the cap counterclockwise (about 1/4 turn until it stops) – this causes the bottom of the cap to be turned to the correct position for installation.
NTurn the cap clockwise for closing – see section on "Closing."
001BA235 KN
NFold the grip down so that it is flush with the top of the cap.
| 1 |
| 001BA238KN |
Left: | Bottom of cap is twisted out |
| of the correct position for |
| installation – inner mark (1) |
| in line with outer mark. |
Right: | Bottom of cap in correct posi- |
| tion for installation – inner |
| mark is under the grip. It is |
| not in line with the outer mark |
| on the cap. |
28 | MS 201, MS 201 C |