English
Adjusting the Master Control lever
To adjust the Master Control lever from run Fto cold start l, press and hold down the throttle trigger lockout and throttle trigger simultaneously – set master control lever.
To set the master control lever to warm start n, first set it to cold start l, then push the master control lever into the warm start nposition.
Switching to the warm start nposition is only possible from the cold start l position.
Simultaneously pressing the throttle trigger lockout and blipping the throttle trigger causes the master control lever to jump from the warm start nposition to run F.
To switch off the engine, set the master control lever to Stop 0.
Position cold start l
–if the engine is cold
–if the engine stalls during opening of throttle after starting
–If the fuel tank has run empty (engine stalled out)
Position warm start n
–If engine is warm (once the engine has been running for approx. one minute)
–When the engine has turned over for the first time
–After ventilation of the combustion chamber, if the engine was flooded
Version with Easy2Start
Press the fuel pump bulb several times – even if it is still full of fuel:
–When starting for the first time
–If the fuel tank has run empty (engine stalled out)
Holding the chain saw
There are two ways to hold the chain saw during starting.
On the ground
0011BA007 KN
NPlace the chain saw securely on the ground – assume a steady stance – the saw chain must not touch any objects and also must not touch the ground
NWith the left hand on handlebar, press the chain saw firmly against the ground – thumb wrapped around the handlebar
NPlace your right foot through the rear handle
32 | MS 201, MS 201 C |