English
For all versions
STOP
1
4
2 
3
0011BA011 KN
NPush the hand guard (1) forwards – the chain is blocked
NSimultaneously press the throttle trigger lockout (2) and throttle trigger (3) – set master control lever (4)
Position cold start l
–If engine is cold (even if the engine has stalled during opening of throttle after starting)
Position warm start n
–If engine is warm (once the engine has been running for approx. one minute)
NHold and start the chain saw
When the engine has turned over for the first time
STOP
1
0011BA012 KN
NMove the Master Control lever (1) to the position warm start n
NHold and start the chain saw
Once the engine is running
STOP
1 | KN | |
2 | ||
0011BA013 | ||
|
NPress the throttle trigger lockout and blip the throttle trigger (2); the master control lever (1) jumps to run Fand the engine begins to idle
0011BA001 KN
NPull the hand guard toward the handlebar
The chain brake is released – the chain saw is ready for use.
Open the throttle only when the chain brake is off. Increased
engine speeds with the chain brake on (saw chain is stationary) will quickly damage the clutch and chain brake.
At very low temperatures
NLet the engine warm up briefly with the throttle slightly open
NIf necessary, configure for winter operation – see "Winter Operation"
Switching off the engine
NMove the master control lever to the stop position 0
If the Master Control lever was moved from the position warm start nto stop 0
–afterwards simultaneously press the throttle trigger lockout and the throttle trigger.
34 | MS 201, MS 201 C |