English
213BA022 KN
NPlace the new spring with frame in position in the fan housing – the anchor loop (arrow) must engage the lug in the housing.
NApply suitable tools (screwdriver, punch, etc.) to the recesses and push the spring into its seat in the fan housing – it slips out of the frame in this process.
NFit the rope rotor and tension the rewind spring.
NFit the fan housing and shroud.
Storing the Machine
For periods of 3 months or longer
NDrain and clean the fuel tank in a well ventilated area.
NDispose of fuel properly in accordance with local environmental requirements.
NRun the engine until the carburetor is dry – this helps prevent the carburetor diaphragms sticking together.
NRemove the saw chain and guide bar, clean them and spray with corrosion inhibiting oil.
NThoroughly clean the machine – pay special attention to the cylinder fins and air filter.
NIf you use a biological chain and bar lubricant, e.g. STIHL BioPlus, completely fill the chain oil tank.
NStore the machine in a dry, high or locked location, out of the reach of children and other unauthorized persons.
Checking and Replacing the Chain Sprocket
NRemove chain sprocket cover, saw chain and guide bar.
NRelease chain brake – pull hand guard against the front handle
Fit new chain sprocket
001BA121 KN
–after use of two saw chains or earlier
–if the wear marks (arrows) are deeper than 0.02 in (0.5 mm) – otherwise the service life of the saw chain is reduced – use check gauge (special accessory) to test
Using two saw chains in alternation helps preserve the chain sprocket.
Use only STIHL original chain sprockets to ensure reliable functioning of the chain brake.
44 | MS 362 C |