Adjusting Depth of Cut

The depth of cut can be set from a few fractions of an inch up to 7.8 in (20 cm).

Before adjusting the depth of cut:

:Shut off the engine.

:Engage the chain brake by pushing the hand guard (1) toward the bar nose - the saw chain should be locked.

:Place the saw on the ground and put your right foot in the rear handle and press down.

:Hold the top of the sliding sleeve with your right hand.

:Loosen the star knob (2) with your left hand.

:Adjust the depth of cut (arrow).

:Tighten the star knob (2) firmly.

:Disengage the chain brake.

English / USA

Mounting the Bar and Chain

1

2

 

a

 

KN

t = a : 2

3

001BA105

 

 

You can run chains of different pitches on this chainsaw – depending on the chain sprocket (see “Specifications”):

The chain pitch (1) must match the pitch of the sprocket and the guide bar (for Rollomatic). The drive link gauge (2) must match the bar groove width (3).

The pitch is marked on the chain sprocket and guide bar in inches (e.g. 3/8 or .325). The groove width is marked on the guide bar in millimeters (e.g. 1.6).

If non-matching components of the wrong pitch or drive link gauge are run together on the same machine they may be damaged beyond repair after a short period of operation.

Rescue Saw

31