A. DAILY

1.The exterior should be kept clean at all times to preserve the lustre of the stainless steel. A mild alkaline cleanser is recommended. Use a soft cloth or sponge to apply the cleanser.

CAUTION

DO NOT USE ACID CLEANERS, STRONG CAUSTIC COMPOUNDS OR ABRASIVE MATERIALS TO CLEAN ANY PART OF THE FREEZER EXTERIOR OR PLASTIC PARTS.

2.Clean the sani-tray by lifting up,out,and rinsing and replacing.

B. WEEKLY

1.Check all "O" Rings for excessive wear and replace if necessary.

C. MONTHLY

CAUTION

THEFREEZERHASANAIRCOOLEDCONDENSERAND MUST HAVE PROPER AIR CIRCULATION.

DO NOT PLACE THE E257 FLOOR MODEL FREEZER ANY CLOSER THAN SIX (6) INCHES (15.2 CM) FROM THE WALL.

THECOUNTERMODELFREEZERREQUIRESA3"(7.6 CM)CLEARANCEONTHESIDES,A1"(2.5CM)CLEARANCE ATTHEREAR,ANDA10"(25.4CM)CLEARANCE AT THE TOP.

FAILURE TO CLEAN THE CONDENSER FILTER MAY RESULTINSERIOUSFREEZERDAMAGEANDCOULD VOID THE WARRANTY.

CONDENSERCLEANING

1.For the floor models, remove the sani-tray and insert. Remove the two phillips head screws from the lower front panel and pull panel down and out. Blow the dirt out from the opposite side of the condenser using an air tank, CO2 tank, or vacuum.

2.For the counter model, remove the six phillips head screws from the back panel. Then clean the con- denser using the same method as on the floor model.

3.12 EXTENDED STORAGE

Refer to the following steps for storage of the freezer over any long period of time:

A.Place the STIRRING ONLY-OFF-STIRRING & FREEZING switch in the OFF position.

B.Disconnect (unplug) the freezer from the electrical supply source.

C.With a warm detergent solution, thoroughly clean all parts that come in contact with neutral base mix or flavors. Rinse in clear water and dry all parts. Do not sanitize.

NOTE

Do not let cleaning solution or products stand in the product cylinder during shutdown period.

D.Remove, disassemble and clean the spigot assem- blies and lower bushing. Place these parts in a plastic bag with a moist paper towel to prevent them from becoming brittle.

18