D.Screw the springs onto the studs in plastic flights.

Springs must be screwed into the flights com pletely to provide compression (Fig. 25).

Figure 26. Exploded View of Front Door

Figure 25. Exploded View of Auger

CAUTION

Do not place the mix inlet regulator into the hopper before installing the auger. Attempting to install the auger with mix inlet regulator in place will damage the mix inlet regulator.

E.Install the two plastic flights onto rear of the auger and insert part way into freezer barrel.

F.Install the third plastic flight, push the auger into the freezer barrel and rotate slowly until the auger engages the drive socket.

G.Install the auger support and bearing into the front of the augers with one leg of the support at 9 o’clock.

NOTE

Apply a small amount of Petro-Gel to the surface of the cam on the spigot handle prior to assembly of handle to the spigot body.

H.Install the spigot bodies with O-rings into the front door from the bottom (Fig.26). Push straight up until the spigots are in place. Install rosette caps.

I.Install the front door on the freezer.

J.Install the circular knobs on the freezer studs.

CAUTION

Overtightening or uneven tensioning of circular knobs may cause damage to front door and cause leaking. Hand tighten circular knobs evenly.

Look for the proper seal between the freezer barrel, O- ring, and front door.

K.Install the mix air regulator into the freezer with the air tube to the front of the freezer. (Fig. 27).

Figure 27. Install Mix Inlet Regulators

L. Thread agitator onto blender agitator shaft. (Fig. 22).

NOTE

Refer to Section 3.3, for sanitizing the assembled freezer before filling with mix.

15