Figure 19. Auger Flight Wear and Front Auger
Support Bushing Wear
D.Place the FREEZING CYLINDER
To disassemble the freezer, refer to the following steps:
A.Remove the mix inlet regulator from the hopper by pulling straight up.
B.Remove the front door by turning off the circular knobs and then pulling the front door off the studs (Fig. 20).
Figure 20. Removing Front Door
C.Remove the rosette caps from the front door. Push the spigot body through the bottom of the front door and remove. (Fig. 21).
Figure 21. Front Door Disassembly
D. Remove the clear acrylic splash guard from the blender.
E. Remove the blender's agitator from the agitator shaft. Grasp the agitator shaft in one hand, and turn the agitator in a clockwise direction with the other hand (Fig. 22).
Figure 22. Removing Agitator From Shaft
D.Remove the front auger supports and bushings (Fig. 23).
Figure 23. Removing Auger Supports
13