ERROR CONDITION CODE 07

If the control panel displays a Drive Motor Current error (Error Code 07), place the Freezing Cylinder Off-On Switch in the Off position, wait 10 seconds, and return the switch to the On position. If the Control Panel still displays the error condition code, call your Authorized Stoelting Distributor for further assistance.

ERRORCONDITIONCODE09(watercooledmodelsonly) Error 09 conditions are usually caused by insufficient cooling at the freezer's condenser. If the control panel displays a High Pressure Cutout error (Error Code 09), turn the freezer power off. Press the High Pressure Cutout Reset Switch located on the upper, left hand corner of the left side panel. There is a round, black boot covering the reset switch. Pressing in the center of the boot will reset the switch.

Check for proper waterflow through the condenser coil. After the cause of the error is determined and corrected, place the Freezing Cylinder switch to the On position. If the Control Panel still displays the error condition code, call your Authorized Stoelting Distributor for further assis- tance.

ERROR CONDITION CODE 12

If the control panel displays a left hopper sensor error (Error Code 12), place the Freezing Cylinder Off-On Switch in the Off position, wait 10 seconds, and return the switch to the On position. If the Control Panel still displays the error condition code, call your Authorized Stoelting Distributor for further assistance.

ERROR CONDITION CODE 13

If the control panel displays a right hopper sensor error (Error Code 13), place the Freezing Cylinder Off-On Switch in the Off position, wait 10 seconds, and return the switch to the On position. If the Control Panel still displays the error condition code, call your Authorized Stoelting Distributor for further assistance.

ALTERNATINGFLASHINGCONTROLPANELLIGHTS

When the right Freezing Cylinder OFF/ON switch is placed in the ON position and the left Freezing Cylinder OFF/ON switch is left in the OFF position, the green and amber control panel lights will flash in alternating sequence and the message "Frz Cyl Hprs Of" will display on the LCD panel. This indicates that the right freezing cylinder is receiving power, but the hoppers are not being refrigerated. Placing the left Freezing Cylinder OFF/ ON switch in the ON position will return the left freezing cylinder to the SLEEP mode, and keep the hoppers re- frigerated.

22