Figure 7. Front Door and Auger Assembly
To disassemble the freezer, refer to the following steps:
A.Remove the front door by removing the upper and lower plastic shrouds then turn off the knobs, and pull the front door off the studs.
B.Remove the spigot body from the spout by pulling the horse shoe clip up and out. Then pull the spigot body out of the spout. Disassemble by turning off the black plastic knob and removing all loose pieces.
C.Pull the agitator assembly out of the freezer barrel.
D.Keep the rear of the agitator assembly tipped up once it is clear of the freezer barrel to avoid dropping rear seal.
E.Remove the front agitator support bearing and the two agitator blades.
F.Remove the rear seal assembly and disassemble.
G.Wipe socket lubricant from the drive end (rear) of the agitator with a cloth or paper towel.
H. Remove all "O" Rings.
WARNING
DO NOT USE ANY TYPE OF SHARP OBJECT TO REMOVE THE "O" RINGS.
Figure 8. Rear Seal Assembly
6