MAINTENANCE AND SERVICING
8.4Stockton 8 (7126) only, Remove the old centre strip seal and old fixing glue from the left hand door and use a clean, dry cloth to remove all old dust and debris.
8.5Squeeze a generous bead of fresh Stovax Thermic Seal Glue into the rope locating groove. Press the new Stovax rope into the locating groove, placing the joint in the middle of the lower edge of the door.
8.6Stockton 8 (7126)only, apply a bead of fresh Stovax Thermic Seal Glue to the centre seal location on the left hand door.Press a new seal strip into position.
8.7Refit the door and close the door to apply pressure to new rope. Leave the stove closed for at least 12 hours before lighting the stove and using at a low output for approximately one day.
8.8Using the stove with damaged door seals could cause dangerous fumes to enter the room, or the stove to overfire, resulting in damage.
9.ADJUSTING DOOR HINGES
9.1To maintain the safe use of your Stockton, you may need to adjust the door hinges to ensure the safe, correct closing of the door. Complete this operation as follows.
9.2Open the door to give access to the hinge block fixing nut.
1
Fixing Nut 
Lock Nut
9.3Using a 20mm A/F spanner loosen the fixing nut inside the stove as shown in diagram 1, and reposition the hinge blocks to achieve a correct fit. This may need a trial and error approach to find the correct position.
NOTES
10
