MAINTENANCE

4.4Clean the internal surfaces of the appliance using a wire brush and scraper as required. Vacuum and brush the resulting debris from the stove then give the inside of the appliance a protective coating of light oil, such as WD40®.

4.5Clean the Grate parts with a wire brush, and check the parts for any damage. Replace any damaged parts, if required, and coat all parts with a protective coating of light oil, such as WD40®.

4.6Re-fit cleaned internal parts.

4.7Remove the glass from the door, and discard all old rope and strip seals. Clean the old glue from the door sealing rope grove and remove dust and dirt. Clean the door glass using Stovax Stove Glass Cleaner and a soft cloth, do not use abrasive cleaners to remove tar or soot deposits from the glass.

4.8Replace the glass edge seal with a new seal and re-fit the glass into place in the door.

4.9Fit new door rope seal, gluing it in place with Stovax Thermic Seal rope adhesive. When fitting new door seals we recommend closing the appliance door and leaving for at least 12 hours before using. This allows the adhesive to fully bond to the seal before use.

4.10Lightly oil the door catch mechanism and hinge pins. Avoid getting oil on to the door seals and glass.

4.11To refresh the finish on painted appliances it is possible to re-paint using Stovax Thermolac Stove paint.

4.12We recommend that only genuine Stovax replacement parts are used to keep your Stockton stove in safe and efficient working order. Your local Stovax dealer will be able to provide you with the genuine parts you require.

4.13Heating circuit parts should be maintained in accordance with the individual suppliers recommendation.

15

Page 15
Image 15
Stovax 7129 manual Maintenance