SERVICING INSTRUCTIONS
REPLACING PARTS
1.GENERAL
1.1All principal components can be replaced without removing the stove from its installation, although it will be necessary to remove the door and ceramic outer casing in order to access most components. In order to remove the casing, use the following procedure:
1.2Remove the door retaining nuts using the tool provided and place the door to one side.
1.3Carefully remove the top blanking plate and grille and place to one side, gently remove the top ceramic panel, see diagram 1. If the unit has been connected to a top exit flue, it will be necessary to lift and support the grille and top ceramic panel whilst removing the outer ceramic components.
1
1.4Gently lift the front ceramic panel, and pull away from the
2
1.5Carefully remove the two side panels by lifting, and gently pulling clear of the retaining bolts, see diagram 3. It may not be necessary to remove both of the side panels.
This should allow full access to all major components.
3
2.BURNER UNIT REMOVAL
2.1Turn the gas supply off at the isolation device. Ensure the unit is cool.
Use cover material to front of appliance to protect paintwork etc.
Remove the door and place to one side. (4 nuts).
Carefully remove the ceramic fuel components to a safe place.
Remove front
Remove cover plate fixing bracket (2 wing nuts).
(Small Stoves only)
Unscrew pilot union nut on gas valve. See diagram 4.
4
Viewing slot on Marlborough only
AR0391
2.2Disconnect thermocouple from gas valve. See diagram 2. Remove ignition lead from electrode. (Cut cable tie to ignition lead if required).
17
