Stovax Coal Effect Stove Range Conventional Flue manual Servicing Instructions, Replacing Parts

	SERVICING INSTRUCTIONS
	REPLACING PARTS
6.5	Disconnect the ignition lead from the gas valve.	8.2 Rotate the injector until it is fully removed, and install the
6.6	Undo the two bolts securing the gas valve to the appliance	correct replacement injector. Reassemble and turn the gas
		supply on, check for leaks.
	and remove the valve.
6.7	Replace in reverse order.		9. GAZCO FLUE SURE SYSTEM
6.8	Check all joints for gas leaks. Check operation of the
		.
	thermocouple and ignition lead.
7.1	Turn the gas supply off at the isolation device. Undo the	If the stove has been installed in a restrictive location, it
		may be necessary to remove the stove from its location.
	7. MAGNETIC SAFETY VALVE	9.1 Locate the sensor in the draught diverter opening, and
		gently pull the two wires off the terminals. Undo the two
	thermocouple connection from the back of the gas valve.
		taptite screws and remove the sensor and the two plastic
	Pull the sensor leads clear and remove the interrupter	spacers. See diagram 14.
	block.
7.2	Undo the magnetic valve-retaining nut from the back of the	14
	control valve. Gently tap out the magnetic valve and replace
	with a new unit. Replace the retaining nut and tighten. See
	diagram 12.

7.3Reassemble the interrupter block and leads. Secure the thermocouple connection in the rear of the gas control. (Do not overtighten). Turn the gas supply on and check the entire pipework and valve joints for any leaks.

12

	9.2		Refit a new sensor ensuring the spacers are located between
			the sensor and the bracket. Replace the two leads.
	9.3		If it has been necessary to remove the stove, ensure that all
			disturbed gas joints are checked for gas soundness when
			reinstalled, and repeat the flue clearance test as detailed in
			the Commissioning Section.
				10. PRIMARY AERATION PLATE
	10.1		Turn the gas supply off at the isolation device.
8. MAIN INJECTOR	10.2		Locate the aeration plate on the underside of the airbox
			and remove the Nyloc nut, see diagram 15.
8.1 Turn the gas supply off at the isolation device. Locate the
main injector on the LH side of the airbox, undo the		15
compression nut and pull the pipe clear of the injector
body, see diagram 13, A.

13
A
	AR0381
	10.3 Remove the plate and replace with the correct size, ensure
	that the hole(s) in the plate align correctly with the holes in
AR0389	the underside of the airbox and replace the Nyloc nut.

20