Stow 1000, 2600, 900 Housing, Nut or Screw, Bearing, Spindle, Seal, Spacer, Shim, Flat Washer, Tip

MAINTENANCE

Reference
Number	Description
1	Housing
2	Nut or Screw
3	Bearing
4	Spindle
5	Seal
6	Spacer
8	Fitting Adapter
9	Casing Adapter
10	Shim
11	Flat Washer
12	Tip

VIBRATOR HEADS— MAINTENANCE

Figure 3. Head Parts

CAUTION!

DO NOT allow the vibrator head to wear below the following dimensions: See General Specifications - page11.

The vibrator heads should be inspected and lubricated after every 100 hours of use. Refer to (Figure 3).

To Disassemble a Vibrator Head:

1.Remove the flexible shaft from the head. Heat should be applied to the threads to break down the anaerobic sealant. This will help prevent possible damage to the threads. Threads are left-hand.

2.Remove the casing adapter from the housing. Head should be applied to the threads to break down the anaerobic sealant. Threads are right-hand. (Ref. 9)

3.Remove the hardened tip from the housing. Heat should be applied to the threads to break down the anaerobic sealant. Threads are right-hand. (Ref. 1,12)

VIBRATOR HEADS — PARTS & OPERATION MANUAL — REV. #1 (04/22/02) — PAGE 9