Sub-Zero IH4227, CTWH36, CTWH30 manual F E T Y I N S T R U C T I O N S a N D P R E C a U T I O N S

Models: CTWH30 IH4227 CTWH36

1 16
Download 16 pages 31.05 Kb
Page 4
Image 4

S A F E T Y I N S T R U C T I O N S A N D P R E C A U T I O N S

W H AT TO DO

IMPORTANT NOTE: Read all instructions before using this appliance.

Read this Use and Care Information carefully before using your new ventilation unit to reduce the risk of fire, electrical shock or injury to persons.

Use this unit only in the manner intended by Wolf Appliance

Company. If you have questions, contact us at 800-332-9513.

Before servicing or cleaning unit,

switch power off at service panel and lock the service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means can not be locked, securely fasten a prominent warning device, such as a tag, to the service panel.

Installation work and electrical wiring must be done by qualified

person(s) in accordance with all applicable codes and standards, including fire-rated construction codes and standards.

Sufficient air is needed for proper combustion and exhausting of gases

through the flue (chimney) of fuel burning equipment to prevent back- drafting. Follow the heating equipment manufacturer’s guideline and safety standards such as those published by the National Fire Protection Association (NFPA), the American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE) and the local code authorities.

Ducted fans must always be vented to the outdoors.

To reduce the risk of fire, use only steel ductwork.

This unit must be grounded.

To avoid motor bearing damage and

noisy and/or unbalanced impellers, keep drywall spray, construction dust, etc. off power unit.

For maximum ventilation capability,

the bottom of the hood should be a minimum of 24" (610) and maximum of 30" (762) above the countertop.

Please read specification label on

product for further information and requirements.

Two installers are recommended

because of the large size and weight of this hood.

Your hood motor has a thermal overload which will automatically shut off the motor if it becomes

overheated. The motor will restart when it cools down. If the motor continually shuts off and restarts, contact an authorized Wolf service provider.

Do not use abrasive or caustic cleaners or detergents on this

appliance as these may cause permanent damage.

To reduce the risk of fire and properly exhaust air, be certain to duct air outside. Do not vent exhaust air into spaces within walls or ceilings or into attics, crawl spaces or garages.

4

Page 4
Image 4
Sub-Zero IH4227, CTWH36, CTWH30 manual F E T Y I N S T R U C T I O N S a N D P R E C a U T I O N S