Fig. 5.
5a. Attach levers to bars be removing the existing bolts and using 1/2 x 3-3/4” bolts supplies. Discard harrow tooth washer. Secure using original locknut. Attach connecting bar and adjusting bar on sides of levers as shown in figures. Use a 7/16 x 1-1/4” bolt on the front levers and 7/16 x 1-3/4” bolt on the rear levers. Repeat exact same procedure for lever linkage system on the other end of section.
5b. 2 bar levers for 2 bar attachments have a 3” offset and must be ordered separately. Order PN 8H0200 for one pair. 3 bar levers have a 1-3/4” offset and are supplied with all brackets. 4 bar attachments use 2 bar levers on the front bar and 3 bar levers on the 2nd and 3rd bars.
Fig. 6.
6a. Install 7/16 x 1-3/4” clevis pin in top hole and back-up clip in adjusting bar as shown. Back-up clip allows implement to be backed up without damage to harrow teeth if they do not clear the ground.
Fig. 7.
7a. Lock-up clip shown installed (see arrow) to hold harrow up in a raised position.
CAUTION: After harrows are securely mounted, slowly fold implement wings. Watch for interference between folding parts and correct if there are any problems.
STAND CLEAR WHENEVER RAISING OR LOWERING IMPLEMENT WINGS.