Summit BIM70 user manual Exterior Cleaning, Condenser Cleaning, Condenser surface

Models: BIM70

1 32
Download 32 pages 49.23 Kb
Page 20
Image 20
Exterior Cleaning

Exterior Cleaning

The door and cabinet may be cleaned with a mild detergent and warm water solution such as 1 oz of dishwashing liquid mixed with 2 gallons of warm water. Do not use solvent-based or abrasive cleaners. Use a soft sponge and rinse with clean water. Wipe with a soft clean towel to prevent water spotting.

Stainless steel can discolor when exposed to chlorine gas and should be cleaned. Clean stainless steel with a mild detergent and warm water solution and a damp cloth. Never use abrasive cleaning agents.

NOTICE: Stainless steel exposed to chlorine gas and moisture, such as in areas with spas

or swimming pools, may show some discoloration. Discoloration from chlorine gas is normal.

Condenser Cleaning

1.A dirty or clogged condenser prevents proper airflow, reduces ice making capacity, and causes higher than recommended operating temperatures that may lead to component failure. Have the condenser cleaned at least once every six months.

2.Unplug the ice maker or disconnect power.

3.Remove the 2 screws at the bottom of the front cover. Grasp the lower edge of the front cover at the right and left sides, raise it a little and then pull down.

NOTE: Do not use too much force, as the wire leads connected to the power switch can be inadvertently disconnected.

4.Locate the condenser surface.

Condenser surface

5.Remove dirt and lint from the condenser fins and the unit compartment with a brush attachment on a vacuum cleaner.

6.Reassemble the front cover.

7.Plug in the ice maker or reconnect power.

DO NOT touch condenser fins. They are sharp and can be damaged easily.

19

Page 20
Image 20
Summit BIM70 user manual Exterior Cleaning, Condenser Cleaning, Condenser surface