GAS INSTRUCTIONS | 7 |
| |
|
|
CONNECT GAS SUPPLY
a)To connect gas hose supply: Slide back the collar of the quick discon- nect. Push male fi tting of the hose into the quick disconnect, and maintain pressure(1). Slide the collar closed(2). If it does not engage or lock, repeat procedure.
b)To connect gas hose at the Grill: Slide back the collar of the quick dis- connect. Push male fi tting of the hose into the quick disconnect, and maintain pressure(1). Slide the collar closed(2). If it does not engage or lock, repeat procedure.
Gas will not fl ow unless the quick disconnect is properly engaged.
Check for Gas Leaks
WARNING: You should check for gas leaks every time you disconnect and reconnect a gas fitting.
WARNING: Perform these leak checks even if your barbecue was dealer or store assembled.
Turn on gas supply.
Check for leaks by wetting the connections with the soap and water solution and watching for bubbles. If bubbles form or if a bubble grows, there is a leak.
Note - Since some leak test solutions, including soap and water, may be slightly corrosive, all connections should be rinsed with water after checking for leaks.
DANGER:
Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for leaks. Sparks or flames will result in a fire or explosion which can cause serious bodily injury or death and damage to property.
WARNING: Do not ignite burners when leak checking.
a
(2)
b
(1)
(2)
(1)
