Regulatory Compliance Statements
Your Sun product is marked to indicate its compliance class:
• FederalCommunications Commission(FCC) — USA
• Departmentof Communications (DOC) — Canada
• VoluntaryControl Council for Interference (VCCI) — Japan
Please read the appropriate section that corresponds to the marking on your Sun product before attempting to install the product.

FCCClass A Notice

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructionmanual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at his own expense.
Shielded Cables:Connections between the workstation and peripherals must be made using shielded cables in order to maintain compliance
with FCC radio frequency emission limits. Networking connections can be made using unshielded twisted-pair (UTP) cables.
Modifications:Any modifications made to this device that are not approved by Sun Microsystems, Inc. may void the authority granted to the
user by the FCC to operate this equipment.

FCCClass B Notice

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Theselimits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
usesand can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
toradio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorientor relocatethe receiving antenna.
• Increasethe separation between the equipment and receiver.
• Connectthe equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consultthe dealer or an experienced radio/television technician for help.
Shielded Cables:Connections between the workstation and peripherals must be made using shielded cables in order to maintain compliance
with FCC radio frequency emission limits. Networking connections can be made using unshielded twisted pair (UTP) cables.
Modifications:Any modifications made to this device that are not approved by Sun Microsystems, Inc. may void the authority granted to the
user by the FCC to operate this equipment.