
4-6 SunFastEthernetAdapter User Guide—November 1994
4
If SunFastEthernet hardware was not installed when the Solaris 2.3 Hardware:
8/94 software distribution was installed using one of the last four clusters,
then the driver is not automatically installed via suninstall, instead, the driver
must be installed using the pkgadd command. Refer to Section 4.2.3, “Adding
SUNWbmac Using pkgadd Command,” on page 4-3“.
4.3.1 Net-Install ServersNote – The Solaris CD cannot be used to do a net-install (read only), thus the
following section is applicable only when the Solaris CD image is archived to a
disk.
Toallow net-install over the be interface the be minor-device- number must be
added to your particular architecture’s name_to_major file. Todetermine the be
minor-device-number proceed as follows:
1. Determine the directory where the Solaris CD image is loaded.
For example, if the Solaris softwareis located within a directory named DIR,
then type the following:
2. Use the ls command to list the directory contents.
Different directories for supported architectureswill be listed.
Table4-3 Solaris 2.3 Hardware:8/94 CD
Cluster Size
Entire Distribution plus OEM Support 298.80 MByte
Entire Distribution 298.1 MByte
Programmer 220Mbyte
End User System Support 125.37 MByte
Core System Support 59.88 MByte
#cd DIR/export/exec/kvm