Sunbeam 1629-020, 1629-040 H, O, F, D

This dryer is equipped with an Appliance Leakage Current Interrupter (ALCI) for your

safety. This device is designed to make the appliance inoperable under some abnormal

conditions(such as accidental immersion in grounded water).

After the appliance is plugged in, you must check your protective device as follows:

1. Press the “Reset” button on the ALCI device.

2. Press the “Test” button. The “Reset” button will pop out. This verifies that the

protectivedevice is working properly.

3. Press the “Reset” button once more to reactivate the safety device and use

yourappliance.

If your protective device does not operate as described above, please contact your

Authorized Sunbeam dealer.

For your protection, this unit contains a thermostat that prevents the dryer from overheating.

Should the air intake and/or air outlet become blocked or obstructed, the hair dryer will

automatically shut off. If this occurs, slide the switch to “OFF,” unplug and allow dryer

tocool. If dr yer continues to turn off automatically, discontinue useand contact your

Authorized Sunbeam distributor.

TOUSE

1. Remove handset from base unit and pull handset cord to desired length – max length

is5.5 feet.

2. Hair dryer will turn-on automatically when the on/off button on the handle is pressed

and held.

3. When finished, return handset to base unit.

4. Press cord retract button to retract cord into base unit.

a. Power settings:

• Low – low air, low heat

• Medium – high air, medium heat

• High – high air, high heat

b. COOL SHOT on all power settings – eliminates heat

c. Retractable cord button

d. Night light switch

CAUTION

Use your Sunbeam hair dryer with care. Directing a high volume of heat continuously to

one area can overheat hair and scalp. When using a “HIGH” heat setting, hold the blower

opening a few inches away from the hair, drying one section at a time. Work layers of hair

in quick strokes. Keep the dryer in motion until drying and styling are complete..