76
MOUNTING INSTRUCTIONS
For use on sheetrock or wood walls only.
The Sunbeam wall mount hair dryer is designed for installation on sheetrock or wood
wallsonly. To mount onto wall, be sure there are no hidden electrical circuits or pipes
inthe mounting location.

PLUG-INMODEL 1629-020

1.
Remove wall bracket from the unit.Push bracket
clip inside housing cavity as shown to release
bracket.
(See Figure A )
2. Use the bracket as template to mark position
ofholes for drilling.
3. Drill four 1/4-inch holes.
4. Insert the four anchors by tapping lightly
witha hammer.
5. Position wall bracket and use screws to fasten.
(SeeFigure B)
6. Engage base unit to wall bracket. Rotate the top
of baseunit towards the bracket upper clip until it
snaps intoplace. (SeeFigure C)
7. Plug the unit into nearby electrical outlet.

HARDWIRE MODEL 1629-040

PRECAUTIONS:Remove power from electrical
terminal before making wire connections.
1. Remove wall bracket from the unit.
2. Use the bracket as template to mark position
ofholes for drilling.
3. Drill four 1/4-inch holes.
4. Insert the four anchors by tapping lightly
witha hammer.
5. Position wall bracket and use screws
tofasten. (See Figure B)
Figure B
Figure A
Figure C
6. Connect base unit wires to the wires from wall junction box using supplied wire nuts.
Make sure wiring is routed through the lower opening on the bracket as shown.
(SeeFigure D) Push wiring into junction box.
7. Engage base unit to wall bracket. Rotate the top of baseunit towards the bracket
upperclip until it snaps into place. (See Figure C)
8. Secure base unit to bracket by tightening supplied anti-theft screw on top of the unit
asshown. (See Figure F – Model 040 Only)
S

TORAGE

1. This product is designed to mount on a wall for both use and storage.
2. Always store handset inside the base.
3. Do not mountor store dr yer in an area with excessive heat or moisture.
4. Do not hang dryer by cord or use cord as a handle
Figure E
Figure F
Figure D