Sunbeam 1632 instruction manual U S E, W E R W a T T a G E C O N S U M P T I O N, O R a G E

T O U S E

1.Remove hair dryer from cradle.

2.To start the dryer, press the ON button on the wall mount unit.

3.Slide the control switch to: LOW position for styling hair, HIGH position for fastest drying.

4.Stop the dryer by pushing the OFF button or by replacing the unit to the mounting base, which will automatically engage the OFF switch.

For your protection, this unit contains a thermostat that prevents the dryer from overheating. Should the air intake and/or air outlet become blocked or obstructed, the hair dryer will automatically shut off. If this occurs, slide the switch to OFF, unplug and allow dryer to cool. If dryer continues to turn off automatically, discontinue use and contact your nearest authorized Sunbeam distributor.

CAUTION – Use your Sunbeam hair dryer with care. Directing a high volume of heat continuously to one area can overheat hair and scalp. When using a “High” heat setting, hold the blower opening a few inches away from the hair, drying one section at a time.Work layers of hair in quick strokes. Keep the dryer in motion until drying and styling are complete.

L O W E R W A T T A G E C O N S U M P T I O N

CARING FOR YOUR HAIR DRYER

S T O R A G E

1.Always store dryer inside the base.

2.Do not mount or store dryer in an area with excessive heat or moisture.

3.Do not wrap cord around dryer. Allow to hang loosely from dryer.

4.Do not hang dryer by cord or use cord as a handle.

5.Store in a cool, dry place and out of reach of children.

6.Store where dryer will not be accidentally damaged from bumping or falling. Do not put anything on top of dryer.

M A I N T E N A N C E , C A R E & C L E A N I N G

1.	Always unplug dryer from outlet before cleaning.
2.	Clean dryer by wiping with a soft, lightly moistened cloth.
3.	NEVER IMMERSE HAIR DRYER IN WATER.
4.	The motor never needs oil or grease.
5.	Check the removable lint screen. It is important that you clean the
	removable lint screen when hair, lint or dust begin to build up on

For lower wattage consumption, there is an optional 1200/1500 switch found behind the

lint screen. (Patent Pending)

1.Remove lint screen.

2.Locate wattage switch and move to the desired wattage.

3.Replace lint screen.

Removable Lint Screen

it.To remove the screen, rotate counter-clockwise and loosen.To

clean, brush the outside of the screen with a toothbrush to loosen

lint, etc.Then turn the screen over and rinse under a running

faucet.Towel dry the screen thoroughly. If inside of screen is dirty,

brush gently with a toothbrush to clean.To replace screen, line up

pegs on inside of the screen with slots on side of unit and rotate

clockwise to lock in place.

N I G H T L I G H T F E A T U R E

(1632-040 model only)

To change bulbs, follow instructions below.

1200/1500 Wattage Switch

(Close-up)

1.To remove lens:

Insert tool (screw driver, knife point, etc.) in crevice.

2.Replace bulb and lamp holder as an assembly by pulling straight out. Each bulb can be replaced separately.

4 5