TO CLEAN ELECTRONIC COLLECTING CELL
NOTE: Whenhandlingthecollectingcell,careshould betakentoavoiddamagingwiresandmetal plates. Do not wash Charcoal Filter. Do not wash Electronic Collecting Cell in dishwasher.
Use dishwashing detergent and the hottest water availabletomakeagoodsoakingsolution.
NOTE: If | the | Cell is | extremely | dirty, spray the cell with | ||
a | householdcleaningagentsuchas | 409, | Fan- | |||
tastik | or Lysol. | Let the | cell soakfive | (5) | minutes |
beforeproceedingtowashinginstructions.
CompletelyimmersetheCellandsoakfor20to30
minutes. .
After the Cell has soaked sufficiently, it should be shakenvigorouslyinwateruntilclean.(Figure9)
Thoroughlyrinsebothsidesofthecell.Ifasprayeris available, spray with water. (Figure 10) Check to make
surethecellplatesareclean.Carefully wipe with a
Repeat the above last 3 paragraphs if necessary.
Figure 9
Figure 10
Shake as much water out of the cell as possible. Replace Cell in the unit as described below and oper- ateunitin“FANONLY”positionforaminimumofone hourtoinsurecellisthoroughlydry.
TO CLEAN NEGATIVE
ION GENERATOR NEEDLE
Make sure the air cleaner is turned off and unplugged from the electric power source for approximately 1 minute before cleaning needle.
Thenegativeiongeneratorneedleislocatedinthe right rear of the air cleaner (Figure 11) and should be cleaned at least every 60 days.
Simply use cotton | swab | dipped in alcohol and wipe off |
the dirt from the needle. | Using a dry cotton swab, make | |
sure the needle is | dry. |
|
Figure 11
TO REPLACE ELECTRONIC COLLECTING CELL AFTER CLEANING
NOTE: UsedirectionsontopofCellforproperplace- ment of the filters into the Cell and for replacing theCellintotheunit.Unit will not operate
properly if the Cell is not replaced correctly.
Slidethe
SlidetheCharcoalFilterintheslotsprovidedinthe
back of the Cell. (Figure 13)
Usingthecellhandles(Figure14),aligntheCellwith theribs(Figure14)ontheinsidecabinetwall.Gently slideCellintoplace.
3