Sunbeam 2576 Operation, Care Of Cabinet, To Remove Hepa Filter Assembly, Figure Figure

OPERATION

Plug the cord into any standard household electrical outlet. (See data label for electrical specifications and power consumption. This data label can be seen when the cabinet top is removed.)

Turn the unit on by sliding the ON/OFF switch to the desired speed: “DAILY USE, MEDIUM or HIGH”. (Fig- ure 4) The air cleaner should be set on HIGH for 1 minute before switching to desired speed to initially start-up the unit. Your air cleaner is designed for con- tinuous operation -- peak efficiency is obtained when the air cleaner remains on constantly. For best results, select “DAILY USE” setting.

An operating light is located on the top right front grill and indicates that the unit is operating. (Figure 5)

MAINTENANCE

CARE OF CABINET

You should treat the cabinet of your air cleaner as you would any other piece of fine furniture. A soft, damp cloth will keep it clean and attractive for many years. The front grill can be cleaned using a vacuum cleaner with a brush attachment.

TO REMOVE HEPA FILTER ASSEMBLY

Turn off the air cleaner and unplug it from the electri- calpowersource.

Remove the cabinet top by lifting up and remove the Sealing Label (enables 99.97% efficiency) from the top of the HEPA Filter Assembly. Do not discard Sealing Label. Lift out the collector assembly using the flip-up handle. (Figure 6)

The HEPA Filter Assembly includes:

Aluminum Pre-Filter, HEPA Filter and Charcoal After-Filter.

The front filter (Aluminum) is the Pre-Filter. The HEPA Filter is the middle (large) filter, and the Charcoal After- Filter is in the back of the HEPA Filter Assembly. (Fig- ure 7)

Figure 4

Figure 6

Figure 5

OPERATING	CHARCOAL
LIGHT
	AFTER-FILTER
	HEPA
	FILTER	HEPA
	ALUMINUM	, FILTER
		ASSEMBLY
	PRE-FILTER

Figure 7