Sunbeam 3206 Operation Of Your Cordless Kettle, Care And Cleaning Of Your Cordless Kettle

OPERATION OF YOUR CORDLESS KETTLE

PRIOR TO FIRST USE

It is recommended that you clean your new kettle thoroughly before using it for the first time. To do this, fill the kettle with fresh water and boil. Discard the water and repeat. Discard the water and rinse the kettle with cold water. Follow the instructions as stated below.

INSTRUCTIONS FOR REGULAR USE

1.To fill the Kettle, hold and gently squeeze the handle. The Spout Cover will open.

2.Fill with the desired amount of water.

Note: Do not fill with less than the minimum level as indicated on the Kettle, or more than the maximum level as the water may spill over when boiling.

3.Plug Power Base cord into a power outlet.

4.Position the Kettle onto the Power Base so that the Switch Housing rests over the Switch. Press the ON/OFF Switch downwards, located at the back of the Kettle. The water will start heating and the Kettle will switch off automatically once the water has boiled.

Note: Ensure that the reset lever is clear of obstructions. The Kettle will not turn off if the reset lever is constrained.

5.Lift the Kettle from the Power Base and pour the water.

6.The Kettle can be stored on the Power Base when not in use. The Kettle will not re-boil until the ON/OFF Switch is pressed downward.

Note: Ensure the power is turned off when kettle is not in use.

Should you accidentally allow the Kettle to operate without water, the boil dry mechanism will operate. If this should occur, allow the Kettle to cool before filling with cold water and re-boiling.

Cord Storage Facility

Excess cord can be stored by feeding the cord into Storage Cavity underneath the Power Base. Select any one of the 3 cord exits most convenient to connect the cord to a power outlet.

CARE AND CLEANING OF YOUR CORDLESS KETTLE

Mineral deposits in tap water may cause the water gauge and the inside of the Kettle to discolor after frequent use. To remove this build-up, fill the Kettle with 3 cups of white vinegar and the remainder with water and allow to stand overnight.

Empty the solution from the Kettle. Any stain remaining just inside the spout can be removed by rubbing with a damp cloth.

Fill the Kettle with clean water and bring to boil. Repeat and the Kettle will be then ready to use.

Always disconnect the appliance from the power point before cleaning. Never immerse the Kettle Switch area, cord, or the Cordless Power Base in water or allow moisture to come into contact with these parts.

The outside of the Kettle can be wiped over with a damp cloth.

CAUTION. Never use any chemical, steel wool, or abrasive cleaners to clean the outside of the Kettle.

5