Sunbeam 3289, 3287 Using Your Coffee Maker’S Controls, Filling The Water Reservoir

Models: 3289 3287

1 32
Download 32 pages 11.06 Kb
Page 5
Image 5
USING YOUR COFFEE MAKER’S CONTROLS

USING YOUR COFFEE MAKER’S CONTROLS

Power Switch – This switch controls power to the Coffee Maker. This is a rocker switch with a momentary contact to turn “ON” and a positive “OFF” position (right side).

On Light – This button indicates that power is going to the Coffee Maker and the Coffee Maker is in normal operating stage.

FILLING THE WATER RESERVOIR

Open the hinged water reservoir cover located at the top of the Coffee Maker. Fill the carafe with the desired amount of cold water. Empty the water from the carafe into the water reservoir. POUR SLOWLY WHEN CARAFE IS FULL. Close the hinged lid. Place the carafe

with the lid in place on the warming plate.

NOTE: The amount of brewed coffee after the brewing process will always be slightly less than the amount of water placed into the Coffee Maker, since some water is absorbed by the coffee grounds and filter. Add a little extra water at the beginning so that you have the exact number of cups desired.

PUTTING IN THE COFFEE

Pull the filter basket straight outward. Insert a standard flat paper filter into the filter basket or a pre-prepared coffee pack.

Place the desired amount of ground coffee into the filter. Use 1 tablespoon of coffee per cup (5 oz.) of water. One coffee scoop equals 2 tablespoons.

After using your Coffee Maker several times, the amount of coffee may be adjusted to suit your particular taste, by decreasing or increasing the amount of coffee used. Be sure to use coffee ground specifically for automatic drip coffee makers. Snap basket into place.

CAUTION: Do not operate your Coffee Maker if the basket is not inserted completely. If the basket does not insert completely, check to see that the filter packet is properly seated and snap basket into place.

Turn switch “ON” to start the brew cycle. The “ON” Light will go on, indicating that the Coffee Maker has begun the brewing cycle. In a few minutes the Coffee Maker will complete the brewing cycle and switch over to the warming mode.

With the Auto-Off feature, the unit will turn itself “OFF” after 1 hour. To continue heating the coffee, simply turn the unit “OFF” and back “ON” again for another hour of heating.

Turn switch to “OFF” when the carafe is empty or when the Coffee Maker is not in use.

HINTS FOR GREAT TASTING COFFEE

A clean Coffee Maker is essential for making great tasting coffee. Regular cleaning, as specified in “Cleaning Your Coffee Maker,” is highly recommended.

Always use fresh, cold water in your Coffee Maker.

Store coffee in a cool, dry place. Once coffee has been opened, keep it tightly sealed in the refrigerator to maintain freshness.

PREPARING COFFEE MAKER FOR BREWING COFFEE

Place your SUNBEAM® Coffee Maker on a flat, level surface away from any edge.

Plug the unit into a 120 Volt 60 Hz AC only outlet.

The lid of the carafe must be properly snapped on during the brewing process and the carafe must be set on the warming plate.

The filter basket must be properly snapped in during the brewing process.

5

Page 5
Image 5
Sunbeam 3289, 3287 instruction manual Using Your Coffee Maker’S Controls, Filling The Water Reservoir, Putting In The Coffee