◆
3

WELCOME

Congratulations on your purchase of a SUNBEAM®Iron! We have designed your iron to provide
the utmost in quality, ease of use and convenience.
Your SUNBEAM®iron offers the following features:
❏Auto-Off – Automatically stops the iron from heating after 30 minutes.
❏Non-Stick Surface – Prevents starch residue and fabrics from sticking to the bottom, making the
iron easier to clean.
❏360° Tangle-Free Cord – Keeps the power cord off the fabric and out of your way, whether
you are right or left handed.
❏SPRAY MIST®– Provides a fine mist of water to dampen fabrics for creases or to remove
wrinkles from heavy fabrics.
❏Large Water Fill Hole – Allows you to fill the water reservoir faster.
❏Power “ON” Indicator Light – Lights while the iron is heating and turns off after 30 minutes.
❏Soleplate – Has steam vent grooves for added convenience when ironing shirts and blouses.

SPECIAL INSTRUCTIONS

❏This is a 1200-Watt appliance.*To avoid a circuit overload, do not operate another high
wattage appliance on the same circuit.
❏If an extension cord is absolutely necessary, a 10-ampere cord should be used. Cords rated
for less amperage may overheat. Care should be taken to arrange the cord so that it cannot
be pulled or tripped over.
For Products Purchased in the United States
To reduce the risk of electrical shock, this appliance has a polarized plug (one blade is wider than
the other). This plug fits a polarized outlet only one way; if the plug does not fit fully into the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this
safety feature.
* In Mexico the iron runs at 127 Volts, 1350 Watts. If an extension cord is necessary a 13-Ampere cord should be used.

IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety precautions should always be followed, including
the following:
❏
READ ALL INSTRUCTIONS BEFORE USING THIS IRON.
❏Use iron only for its intended use.
❏To protect against risk of electric shock, do not immerse the iron in water or other liquids.
❏The iron should always be turned to “Off” before plugging or unplugging from outlet.
Never yank cord to disconnect from outlet; instead, grasp plug and pull to disconnect.
❏Do not allow cord to touch hot surfaces. Let iron cool completely before putting away.
Loop cord loosely around iron when storing.
❏Always disconnect iron from electrical outlet when filling with water or emptying and when
not in use.
❏Do not operate iron with a damaged cord or if the iron has been dropped or damaged.
To avoid the risk of electric shock, do not disassemble the iron. Take it to an authorized
service center for examination and/or repair. Incorrect reassembly can cause a risk of
electric shock when the iron is used.
❏Close supervision is necessary for any appliance being used by or near children.
Do not leave iron unattended while plugged in or turned on or on an ironing board.
❏Burns can occur from touching hot metal parts, hot water or steam.
❏Use caution when you turn a steam iron upside down – there may be water in the reservoir.
❏If the iron is not operating normally, disconnect from the power supply and have the iron
serviced by an authorized service center.
❏Your SUNBEAM®iron is designed to rest on the heel rest. Do not leave the iron
unattended. Do not set the iron on an unprotected surface, even if it is on its heel rest.
SAVE THESE INSTRUCTIONS
02-2029 iron brochure 6/19/02 10:34 AM Page 3