Sunbeam 7652 instruction manual Pressure, Replace, Batteries, Measurement Error, Pulse error

		Mark appears in the mea-					Measurement in progress -
		surement	condition			and	remain	quiet.
Measurement in		flashes when		pulse		is
progress		detected.
		Mark flashes when power is					Automatic exhaust is per-
		applied and there is air					formed.
		remaining	in	the cuff.
Exhaust
A.	,	Measurement		has		begun	Raise the cuff
		but the pressure was					pressure 30-40 mmHg
Insui’ficient		insufficient.					more	andmeasure	once
pressure							again.
		Appears when the battery					Replace all four batteries
Replace		voltage is excessively low.					with new ones.
batteries
		Appears	when		the	blood
		pressure	could		not	be
Measurement	error	obtained	accurately.				Exhaust the air from the
							cuff, and re-apply the cuff
PU ERR							properly and re-measure.
		Appears when the pulse					(Wait	10 minutes	before
		rate could not be obtained					re-measure)
Pulse error		accurately.