Before using your Café Espresso® II
Before using your Sunbeam Café Espresso®
IIfor the first time or if you have not used it for some time, rinse the machine by running water through without coffee in the group handle, as follows:
Note: Throughout these instructions the numbers you see highlighted and in brackets refer back to the diagrams at the start of this instruction manual.
•Open the lid of the water reservoir (1) and fill with cold water (2). Alternatively you can open the lid and remove the water reservoir using both hands (3). Then fill with cold water (4).
•Replace the water reservoir firmly into the unit (5) and close lid.
•Insert the power plug into a
power outlet and turn the power (
) on. Start the unit (6). The red power (
) light will illuminate and flash to indicate it is warming up.
•Place one of the filters in the group handle
(7). Then position the group handle on the machines brewing head (8).
•To ensure that the group handle is in the correct position, turn the handle so it points to the left and place the group handle flat against the brewing head (8), then turn the handle towards the right (9), as far as it can go.
Note: Do not over tighten.
•Place a sufficiently large container under the group handle pouring spouts (10).
•When the power button has stopped flashing and is completely illuminated, the machine is ready for the next step.
•Turn the dial to the espresso (
) setting (11) and allow all the water in the water reservoir to run through.
•If necessary, you may need to stop the operation by turning the dial to the off
(
) position, empty the container, then resume the operation.
Note: Make sure that the water reservoir is clean and free of any debris, as any fine particles can block the water flow.
13
